IMI International Millennium Mining Corp

International Millennium Mining Corp. (TSX VENTURE:IMI) (the "Company" or
"IMMC") has commenced the second phase of a drilling program at its Nivloc
Silver and Gold Project located in southwestern Nevada. The holes in this
program are designed to tighten the drill spacing in parts of a target area
drilled with 34 holes in 2011 and to expand the currently defined mineralized
zone by stepping out along strike towards the northeast and southwest. 


Assays have been received from Holes 11NL-31 and 11NL-34 (see drill highlights
and table below), located in the western part of the Nivloc Vein Structure. All
4 holes were collared from pad 4 and are part of a systematic drilling program
designed to test a 1,200 foot long by 600 foot vertical, un-mined zone within
the Nivloc Mine. This target zone, which is crossed by access/haulage drifts
that were developed on four levels while the mine was in production, lies
between two partially mined areas exploited by Desert Silver between 1937 and
1942. Three of these holes were designed to test the upper part of the target
area, above the area outlined by previous drilling. 


All holes intersected the Nivloc host structure with the best intersection being
from the deepest hole, 11NL-31.


Drill Highlights from hole 11NL-31: 

53 feet @ 92.3 g/t Ag and 0.86 g/t Au - Main Nivloc vein, including: 

22 feet @ 165.3 g/t Ag and 1.88 g/t Au - Main Nivloc vein

Hole 11NL-31 intersected the Nivloc vein system between the 700 and 800 ft
levels, in the western portion of the target area, 200 feet east of the
westernmost mine workings. 


Holes 11NL-32 intersected the zone beneath the 440 ft level. Holes 11NL-33 and
11NL-34 were aimed above the 440 ft level with the latter intersecting the zone
at its shallowest point to date (200 ft level). The holes show a weakening of
grade in this area, although 11NL-34 is thought to have drilled down an
offsetting fault structure, missing the better part of the zone. The level
numbers referred to above, along with distances from other features, are deemed
to be approximate. 


Drill Hole Results



----------------------------------------------------------------------------
Hole No.(3)                                                      Width (ft) 
                AZ degrees    Dip degrees   Interval (ft)         (drill) 
----------------------------------------------------------------------------
11NL-31                 055             -86   876.0 - 929.0            53.0 
----------------------------------------------------------------------------
Including                                     896.0 - 918.0            22.0 
----------------------------------------------------------------------------
11NL-32                 116             -63   624.5 - 713.0            88.5 
----------------------------------------------------------------------------
Including                                     624.5 - 660.0            35.5 
----------------------------------------------------------------------------
Including                                     629.0 - 635.0             6.0 
----------------------------------------------------------------------------
11NL-33                 090             -68   610.0 - 746.0           136.0 
----------------------------------------------------------------------------
Including                                     739.0 - 746.0             7.0 
----------------------------------------------------------------------------
11NL-34                 109             -47   621.0 - 657.0            36.0 
----------------------------------------------------------------------------
Including                                     626.0 - 629.8             3.8 
----------------------------------------------------------------------------

--------------------------------------------------------------------------
Hole No.(3)     Width (ft)                                                
                (estimated                                            Vein
                  true)(1)        Ag (g/t)        Au (g/t)  Description(2)
--------------------------------------------------------------------------
11NL-31               35.4            92.3            0.86             MNV
--------------------------------------------------------------------------
Including             14.7           165.3            1.88             MNV
--------------------------------------------------------------------------
11NL-32               68.0            25.1            0.23             MNV
--------------------------------------------------------------------------
Including             27.3            45.5            0.50             MNV
--------------------------------------------------------------------------
Including              4.6           106.0            0.80             MNV
--------------------------------------------------------------------------
11NL-33               75.6            10.1            0.07             MNV
--------------------------------------------------------------------------
Including              3.9            31.7            0.16             MNV
--------------------------------------------------------------------------
11NL-34               27.9            36.7            0.19             MNV
--------------------------------------------------------------------------
Including              2.9           142.0            0.13             MNV
--------------------------------------------------------------------------



(1) Estimated true widths are calculated and may change slightly with additional
structural information. 


(2) Main Nivloc Vein (MNV). 

(3) Previous drill hole results are set out in the Company's prior news releases.

As mentioned above, the current drilling program is focused on a target area
that lies between previously mined zones within the northeast-southwest-trending
Nivloc vein structure. A strongly mineralized zone has been outlined between the
440 and 800 ft level drifts in the old mine workings with lower grade
mineralization above the 440 ft level. The 800 ft mine level is approximately
900 feet vertically below surface, and the vein and workings dip from minus-45
to minus-65 degrees toward the northwest. Previous mining at Nivloc focused on
high-grade lenses of ore that were encountered while drifting along the vein
structure. The current IMMC drilling program indicates the Nivloc structure
ranges from 50 to more than 150 feet wide and contains several parallel vein
zones. It appears, from available data, that only one of these parallel vein
zones was exploited by prior mining activity in the 1930s and 1940s. In addition
to the potential for high-grade lenses similar to those mined in the past, the
material between the lenses is consistently mineralized and the entire structure
may have potential as a low-grade, bulk-minable deposit. 


Part of the 2012 drilling program will be directed beneath and 500 feet west of
the most westerly workings, and to the northeast of the main workings in order
to test the mineralized zone beyond the current target area. 


Information from the current drilling program has been incorporated into a
geological model for the Nivloc deposit. The results are currently being
evaluated for the purpose of converting the data into a NI 43-101 compliant
resource for the area drilled and to determine locations for additional
drilling. 


John A. Versfelt, President and Chief Executive Officer of the Company,
comments, "With the consistent excellent drill results that we continue to
intersect at Nivloc, the Company is pursuing its plan to drill throughout 2012
to build the NI 43-101 resource." 


Thomas L. Evans, PGeo, the Company's qualified person under NI 43-101 in charge
of the drilling program, reviewed and approved the technical disclosure of this
press release on behalf of the Company. 


International Millennium Mining Corp., through its wholly owned subsidiary
International Millennium Mining Inc., has an option agreement with Silver
Reserve Corp. (SRC), a wholly owned subsidiary of Infrastructure Materials Corp.
(OTCBB: IFAM) to acquire an 85% interest in SRC's 18 claim NL Property, which
forms part of the Nivloc Property. 


The drill assay intervals were calculated using the weighted average method.
Drill core assaying was conducted by ALS Minerals, which is an ISO-certified
laboratory. The Company has implemented a quality assurance/quality control
program to ensure that sampling and analysis of all samples are conducted in
accordance with the best possible practices. The system includes the use of
standards, blanks and duplicates to ensure analytical accuracy and the
submission of duplicate samples to a second laboratory to verify the integrity
of the analytical results.


International Millennium Mining Corp. (TSX VENTURE:IMI) is a mineral exploration
and development company engaged in acquiring known smaller mine deposits, such
as its Nivloc, Nevada silver-gold mine project, in the Americas, with the goal
of advancing the properties to the mining stage. Emerging targets include
silver, gold, copper, zinc and lead. The Company's common shares trade on the
TSX Venture Exchange under the symbol: IMI and on the Frankfurt Exchange under
the symbol: L9J.


ON BEHALF OF THE BOARD

John A. Versfelt, President & CEO

Further information about the Company can be found on the IMMC website
(www.immc.ca), on SEDAR (www.sedar.com).


This news release may contain forward-looking statements including but not
limited to comments regarding the timing and content of upcoming work programs,
geological interpretations, potential mineral recovery processes and other
business transactions timing. Forward-looking statements address future events
and conditions and therefore, involve inherent risks and uncertainties. Actual
results may differ materially from those currently anticipated in such
statements.

International Millennium... (TSXV:IMI)
Gráfica de Acción Histórica
De May 2024 a Jun 2024

International Millennium... (TSXV:IMI)
Gráfica de Acción Histórica
De Jun 2023 a Jun 2024